1 installation. Key to verify that is in the off position. 2. remove two covers of the fuel tank of left and right. 3. FlipRemove thesignal lamp mounting fuel tank cover. Remove the lamp socket. 4. cut the wires turn signal light of 5. Two pieces of mm Ø 3.5 heat shrink tube and put them in you just cut. 6. Peel 5-10 mm of insulation from the end of wires. Pick up the signal input wires and solder them to the wires of light, while previously reconnecting cut wires. For incoming wires, signal red/white is for the left hand side and Red/Black is to the right side. Note: the polarity is very critical. The black light wire with a white stripe is negative (-) the driver, connect the white (on the left, black on the right side) entered wire signal with it. Connect the red signal input with another light wire (+).
Download
Source Of Free Ebook Manual Download All Programming Automotive Hardware Gadget Update Daily