Schematic circuit

The current of this circuit is determined by following equation:
I=C*(dVin / dt)
And the ouput voltage is determined by following equation:
Vout=-R*C*(dVin/dt)

The problems of this circuit is instabilities at high frequencies and noise. Those problems is caused by op-amp’s internal phase shift and high gain. The second circuit is used to solve those problems. The roll-off components C2 and R1 depends on the bandwidth of the op-amp and the noise level of the signal. This circuit will change to an integrator at high frequencies because of C2 and R1.

application of OP-AMP is differentiator. Differentiator circuit produce an output if the input is changing. The output can positive or negative, depends on the change of the input: whether it’s decreasing or increasing. This circuit is a bias stable. The current is produced by the rate of change of input voltage because the inverting input is grounded. Here is the circuit

search on this page:
Generator Pulse Pic16f84a 38kHz ,infra receiver ,tube preamp schema ,mini Inverter 12v to 220v ,inversor 12v to 220 com mosfet ,switching regulator power supply ,lm317 5a ,simple 5v dc power supply diagram ,NE5532 Headphone Amplifier , lm317 power supply circuit , battery equalizer circuit ,headphone amplifier Cmoy diagram , tone control circuits ,NE5532 Headphone Amplifier