Installation of exhaust system of slip-on: 1. make sure the bike is completely cool before starting the installation. Check if the bike is secure on the sidestand or, ideally, a tour service from the rear. 2. remove the original silencer, taking care not to damage exhaust gasketthe. If you damage the Board you can get a new one from your local Suzuki dealer. In most cases you can reuse the original junta. 3. install the support of "Y" black as shown by removing the rear passenger foot bolt allen and replace it with the supplied allen screws 8 x 55 mm. Tighten firmly the 8 mm x 55 mm screws. Then attach the BRACKET "Y" for the extra segment using the finger nylock nut and washer only tight. Now attach the bottom half of the bracket y using the supplied 8 x 50 mm allen bolt, nylock nut and washer. Now securely tighten the entire set. 4. Remove bumper rubber Center tour of his original tube and install it on the s-bend tube TBR. 5. slide TBR s-curve in exactly as the original header, but do not tighten the clip yet. 6. slide the silencer to the s tube and attach the silencer for the support of "Y" with silencer clamp using the supplied 8 x 25 mm allen bolt, nut and washers, nylock. Note: both ears must press clip together and ride on the outside of the "Y".
Download
