Manual installation of exhaust systems for CT Suzuki Hayabusa 2008

Installation of exhaust systems: Step 1: check the package contents: 1.4 four mounting Flanges 2 header. Four Spigots, 4 3. A 1 right and left side header 1 (primary) 4. A sink of 5. Package containing Springs, Spring extractor and supplementary information 6. One (1) elbow (or two if 2 dual) 7. A silencer (1) CT (or two if 2 dual) 8. A black rubber cover (not shown) step 2: PRE-ASSEMBLE headers, collector, and MID-PIPE to HOLD FIT between all appropriate portions: performance of Brock pre-assembles the exhaust system before it is delivered to your door. We ask for this to ensure there were no submission damages incurred before you start disassembling your bicycle. Many of our customers use WD-40 applied for joints to ease mounting, adaptation and/or disassembly. Step 3: Remove bodywork: remove all push pins, starting with 2 under the motorcycle fairings, holding two side together. Then remove the pins of two push behind the wheel front holding the bottom of the screen for side fairings. Remove the screen (piece of Chin). Remove the belly pan, disconnecting the pins to push back the regulator/rectifier and 4 mm Allen screw on the right side below the assembly of peg and foot brake. Remove mm (2) 4 Allen screws on the right side fairing, and (2) screws below the handle bars (one black, one silver). Repeat on the left side of the bike.
Download Complete 2008 Suzuki Hayabusa CT Installation Manual of exhaust systems.